Rack tooth gang cutters
2021-11-06 10:30:32
jiangxingTools
441
Rack tooth gang cutters
Rack tooth gang cutters are used on the conventional horizontal milling machines as well as on the special automatic rack milling machines. Standardized constructional dimensions therefore do not exist. The above table is intended for guidance and should facilitate the selection of milling cutter overall dimensions. The cutter width depends on the module (m) and the number of tooth rows (n)
Rack tooth gang cutters with several tooth rows for racks to module pitch
20° pressure angle, basic profile Ⅰ to Ⅱ DIN 3972
To process your order correctly, we need in addition to the gear data the required number of tooth rows on the cutter.
相關文章
-
Hub-type gear shaper cutter with DIN 5480
Hub-type gear shaper cutter with DIN 5480Tooth profile to DIN5480 standardModule: m1.5-10Number of t... - PA20° Inserted Blade Gear Hob with Module m22
- PA20° Pre-shaving Gear Hobber Cutter with Module m5
- RS100 Roller Chain Sprocket Hob with Pitch 31.75 x Roller Dia. 19.05
- PA20° Profile DIN3972 Standard Pre-grinding Gear Hobbing Cutter with Module m2.25
- PA20° PCD 100mm Pre-shaving Gear Shaper Cutter with Module m1.25~m6
- PA20° PCD 125mm Bowl Type Gear Shaper Cutter with Module m4~m8
